Publication date: 2018-04-21 15:03
The Enerdrive Active Balancing System also incorporates individual cell “Hi -Voltage & Low-Voltage” disconnect feature to interface with the Enerdrive Advanced BMS Driver, switching (off/on) of charging sources & consumer loads.
Lithium Based Battery Systems are fast becoming the preferred replacement for Lead Acid Battery systems. In applications where weight is everything like caravans, camper trailers, motor homes & 9WD's, lithium batteries are among the lightest options available. Enerdrive has designed a compact and slim case lithium battery range that allows for easy installation and access for maintenance.
It 8767 s more probable a damage to the INSIDE of a single cell rather than cells displacement: electrodes rupture?
Lithium batteries manuals suggest to trash batteries which got damaged when dropped (of course talking about big batteries, several Ah).
In any event, the battery will not fully charge or keep a charge and I am returning it.
Should I ask for a replacement or a refund?
I should have specified that I want to design a hand-held appliance with a light, durable, long-lasting battery. (And not what you may be thinking. That 8767 s been done.)
To be clear I am not talking about balance charging. This is something else. You will inevitable have one cell which has higher capacity than all the other cells. They will drop in voltage at different rates. One cell will drop below volts before the others, then the whole battery will shut down. Once dead, if there is a large difference in voltage between lowest voltage and highest voltage cell, you should take two cells from the highest voltage cell and swap them with two cells of the lowest voltage cell. That way the weakest link will not be so weak and your battery will last longer.
Even better would be to replace the lowest voltage batteries with different ones if available.
Why do Lithium_ion_batteries have three electrical contacts, . + (plus), -(minus) and an unmarked one? Is the latter conected to the charging (safety) circuit?
I need to replace two 67V NiCd batteries from a 6998 camera. Camera eats 75w and NiCd were rated to last for . I bought a 67V 9855mAh Li Ion. It does not output enough power to run the camera longer than 85 or 95 seconds. It still showes but does not power the cam. What did I not understand?
Need to understand mean time to first failure in lithium-ion superpolymer. Any study has been done on this?
This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.